Tweet
People who have been using the new Microfiber system...how much of the compound do you find you use for a full vehicle? I am purchasing the system soon and just trying to decide on what size I want to go with. Thanks!
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: MF system product usage
Very little! You only need 2-3 pea sized drops per section once the pad is primed. If you're just doing your own car the 16oz bottle should last you a while. If you plan to do several cars, the 32oz size would be a little better. I've had my 32oz bottle since December 1st and it's just about gone now.
-
Re: MF system product usage
16oz. bottles of D300 and D301 will last for long. After you prime the discs you use 3-4 pea size dots per section.
I did small SUV (BMW X3) and used maybe 1/5 (maybe even less) of the 16oz. size.Comment
-
Re: MF system product usage
I'll say it also...very little product. All you use is 2-3 pea size drops per section.Tedrow's Detailing
845-642-1698
Treat Yourself to that New Car FeelingComment
-
Re: MF system product usage
Not sure if someone mentioned it yet, but only a small amount is needed per section...like 2-4 pea size drops. hahaComment
-
Re: MF system product usage
Thanks everyone! MF system ordered.Comment
-
Re: MF system product usage
I just picked up my Kit today from Detailing .com, Nice new shop .
So what is the best way to prime the MF
Comment
-
Re: MF system product usage
Marine Toys,
Check out the below link on how to use the system and prime the pads:
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA
nawinn@meguiars.comComment
-
Re: MF system product usage
I believe this is method is correct...I'm sure someone will correct me if I'm incorrect.Originally posted by Marine Toys View Post
Apply a very small amount on the entire surface of the MF disc. You can apply a few lines of product then slowly run the DA on the paint. Look at the disc. See where product is not on the disc and apply product in those areas so the entire surface of the disc has product on it. that's it. The disc is primed.
Clean the disc with compressed air, or in my case I use a dry "Bug Sponge", between each section pass. Apply a few pea size amounts and continue.Comment
-
Re: MF system product usage
Darn! I went through four 32 oz bottles on my car....... a mini cooper.Comment
-
Re: MF system product usage
Your Mini Cooper must look amazing, Joe, after this bath.Originally posted by Superior Shine View Post
Could we see some pics, please?Comment
Comment