• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

G110V2 quick question..

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    G110V2 quick question..

    I am intend to buy G110V2 and it come with W68DA Soft Buff 2.0 DA Backing Plate.
    my question is :
    If I buy soft buff polishing and finishing pad 6.5 in, can this fit with W68DA Soft Buff 2.0 DA Backing Plate,
    or I must buy softbuff 2 7".
    Tags: None
  • #2
    Re: G110V2 quick question..

    The W68DA was made for the Softbuff 2.0 7" pads. However, I've used the original Softbuff 6.5" pads without a problem. The edge of the D/A is very close, if not aligned with the edge of the foam pad so there's very little margin for error. You just have to be careful when buffing around edges or curved panels. As far as functionality goes, it works just fine.
    2011 Car Crazy Showcase SEMA Team

    Comment

    • #3
      Re: G110V2 quick question..

      I am going to buy G110V2 from Amazon.com, but the softbuff 2.0 can' t sent to my country. I am living in a small town in Indonesia, so I can't get this anywhere. The funny thing is G110V2 can sent to my city but the softbuff 2.0 is not and there are coming with same seller.

      Comment

      • #4
        Re: G110V2 quick question..

        Try autogeek.net
        2011 Car Crazy Showcase SEMA Team

        Comment

        Previous template Next
        Working...
        X
        gtag('config', 'UA-161993-8');