• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

Hyper Wash in a foam cannon

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hyper Wash in a foam cannon

    Washed the Dakota today.


    Meguiar's Hyper Wash in the foam cannon and bucket. It did quite well. It has good sticking ability but fairly easy to rinse off. It also cleaned well. Pics were taken about 45 to 60 seconds after application so it has been dripping off but ut was well covered during initial application.

    Pressure Washer: Kranzle 1400 oau
    Cam Spray Foam cannon: 1.5 oz to 15 oz water (coat only required 1/2 reservoir)
    Bucket Wash: 1 oz to 3 gallons (around 1:400)





    It is a great all around soap - foam, easy rinsing, good cleaning, slickness.
    Al
    ~ Providing biased opinions

  • #2
    Its a great soap.
    I just used it for the first time on Thursday and I am very satisfied. Best thing like you said is it washes of easily.
    My go to soap now.

    Comment


    • #3
      Re: Hyper Wash in a foam cannon

      My question is about the dilution ratio.

      Is it 1oz to 3 gallons (1:400)...or 1oz to 5 gallons?

      The instructions on the back state both...

      Comment


      • #4
        Re: Hyper Wash in a foam cannon

        Originally posted by KidDetailer View Post
        My question is about the dilution ratio.

        Is it 1oz to 3 gallons (1:400)...or 1oz to 5 gallons?

        The instructions on the back state both...
        I use 1 ounce with 3-5 gallons of water. No one usually typically fills a whole 5 gallon bucket to the top with water anyways so you'll be fine.

        Comment

        Working...
        X
        gtag('config', 'UA-161993-8');