Tweet
I had posted a thread last night asking if anyone had any tips on how to detail and 02 mustang gt. I got a lot of great responses and they all came in handy today. It turned out to be an 03 mustang gt and upon first inspection it didnt look too bad but would prove to be a little tougher. The owner purchased it from carmax in the winter and they did a number on it with putting in some nice swirls along with chips in the paint if it wasnt done by the previous owner. I started around 10 am and finished at 3 pm it was cold in the morning but warmed up to a beautiful day later on. Overall it was a great car to work on I used the rotary only on the hood and some select stubborn panels. I got it about 90% swirl free. Heres the proces and pictures...
1. Deep Crystal Wash
2. Clay with Mild Clay
3. #83 w/ G100 and 8006
4. #83 w/ rotary and 8006
5. Next Paste Wax
Before Wash
Dirty Dirty
At this point it was only 32 degrees out
Clay from drivers side of the car
Mangled Clay from passenger side of car
Rims cleaned
Post Clay
After pass with #83 w/ rotary
Trunk lid after #83 w/ G100
Roof
Rims shined with never dull
Hood Again
Finished Product
Exhaust Tips after never dull
1. Deep Crystal Wash
2. Clay with Mild Clay
3. #83 w/ G100 and 8006
4. #83 w/ rotary and 8006
5. Next Paste Wax
Before Wash
Dirty Dirty
At this point it was only 32 degrees out
Clay from drivers side of the car
Mangled Clay from passenger side of car
Rims cleaned
Post Clay
After pass with #83 w/ rotary
Trunk lid after #83 w/ G100
Roof
Rims shined with never dull
Hood Again
Finished Product
Exhaust Tips after never dull
Pug 106 GTI Owner 
Comment