View Full Version : Zenith Point Rotary Polishing technique

Dec 20th, 2006, 02:29 PM

Dec 20th, 2006, 02:51 PM
interesting read.

Michael Stoops
Dec 20th, 2006, 04:53 PM
Thanks for sharing that!

Dec 20th, 2006, 10:16 PM

Mike Philips,

could I have your advice /opinion on the above article please?

I really love meguiars product. Recently, car was detailed by [ Hypercoat Enterprise Pte Ltd - sole distributor of Meguiars for Singapore ] using rotary buffer. The car looks wet in normal light but once out of direct sunlight, trails & buffer swirls is quite obviously. I was abit disappoint.

May i have your suggestion please?

From Singapore

Dec 21st, 2006, 03:08 PM
it could be due to the fact the finishing polish was not fine enough,or the finishing speed was a little too fast the above principle is basically start slow to spread and break down the polish,step up to the next speed to remove the defect and then step the speed back down to refine and leave a hologram free finish,you may have to use a finishing pad,or alternatively go round again with a pc to remove the holograms