PDA

View Full Version : The Cav's shaping up



Don
Apr 18th, 2005, 04:51 PM
I've been plaing around with the rotary, last week was DACP and #2, tonight was #9 and a finishing pad. All I can say is WOW. I did the hood first (two passes) working the #9 until it was gone. After wiping it down with a MF, I took a peek in direct sunlight. Talk about taking the finish to a new level, if it wasn't for the 72,000 miles worth of rock chips, the finish would look showroom, not a mark on it anywhere. I went ahead and buffed the rest of the car with the same set up and then wiped it down. Other than the trunk lid it's perfect. Tomorrow, I'll hit the trunk again then cover the whole car with some Collinite Insulator.

I have to say, the #9 with the finishing pad was the easiest experience I've had with the rotary to date. I kept the buffer at about 1.75 on the dial (1,200-1,300 rpms + / - ) and it was so sweet to work with.

I think I'm starting to like this thing.

gb387
Apr 18th, 2005, 05:21 PM
Don

I have been kind of following your experiences with the rotary... I can't remember did you start on the Cav or a panel from the junk yard?

Don
Apr 18th, 2005, 09:17 PM
I got a junkyard hood to practice with first