How to maintain your car's finish in-between polishing sessions
Page 1 of 2 12 LastLast
Results 1 to 10 of 20

Thread: How to maintain your car's finish in-between polishing sessions

          
  1. #1
    Sr. Global Product & Training Spec Michael Stoops's Avatar
    Join Date
    Oct 2004
    Location
    Irvine, CA
    Posts
    21,401
    Rep Power
    1138

    How to maintain your car's finish in-between polishing sessions

    How to maintain your car's finish in-between polishing sessions

    This discussion came up recently so I thought I'd make mention of what I do to my car after I've polished it to perfection (or as close to perfection as I'm able to achieve), so here we go:

    First off, the picture below is of my 2004 PT Cruiser Turbo (purchased new end of December, 2003) just after finishing a multi day process that included washing with Gold Class, clay with the Smooth Surface Clay Kit, M80/W8006 pad on the DA to remove all defects, two coats of M21 Synthetic Sealant (24 hours apart) and two coats of M16 Carnauba (12 hours apart). I went a bit crazy on the 21 and 16 because I was going to be driving the car to Prescott, Arizona for a show and I wanted it to look good when I got there, and be easy to clean up too. The drive was going to about 450 miles, one way, through the desert so I knew it would get dusty, to say the least. Keep in mind this picture was taken March 13, 2007, so just over a year ago.


    When I got to Prescott the car was covered in dust, especially the rear hatch because the aerodynamics of the car just churn the airflow back onto the car, depositing large amounts of dust. So, what to do. I took the bulk off with a California Duster, touching the surface as gently as possible. This still left a fair amount of dust behind, so liberal amounts of Last Touch Spray Detailer and several microfiber towels were used to remove the rest. The car looked great. I stayed in Prescott for a long weekend, then drove home. Of course the car was covered again but at home I could wash it properly.

    So here's my routine:

    Washing Basically one of two ways, either two buckets with Grit Guards in them or one bucket with a GG and clear water and a foam gun for soaping up the car. Heavy rinsing to start, of course. Gold Class, NXT, Super Soap or #62 being my car washes of choice. I only use a natural lambswool wash mitt and I rinse it often during the wash process. Sometimes I'll even give it a blast with the hose to clean it out if I'm feeling extra Car Crazy. The mitt is always machine washed and hung to dry in the garage, then put away as soon as it's dry. You gotta be clean to get clean.

    Drying I always do a final nozzle-off-the-hose rinse to sheet as much water as possible from the finish. Then I use Water Magnet waffle weave drying towels to blot up the rest of the water. It's probably overkill but I'll use as many as three of four towels to dry the car.

    Simple enough, right? Just using extreme caution in everything I do. But here's where it gets interesting. We don't get a lot of rain in SoCal so there isn't always a need to wash every week. But being in or near the desert we have a lot of dust, and with a few gazillion cars on the road we get a lot of fallout as well. To combat this I do the following on a regular basis, sometimes as often as 3 or 4 times a week:

    Quick Detailing I'm using Ultimate Quik Detailer and Ultimate Wipe microfiber towels these days, but prior to their introduction I was using Last Touch and Supreme Shine towels. The key is to do this before the dust accumulation gets to be too extreme. Use plenty of QD and plenty of towels. Don't think you can get away with a light spritz and one towel. Fold the towel in half, then in half again. Spray the QD liberally onto the surface and gently wipe it off, then flip the towel and wipe again. When you see the towel start to show a line of dirt, flip it around and use a different section. With it folded properly you'll get a couple pairs of first wipe/second wipe sections out of it. But if you use a good amount of QD you'll get the towel pretty damp rather quickly. I'll go through 4 or 5 towels to wipe down this car, and it's a smallish vehicle. Just wipe enough to get the dust off, don't go crazy trying to buff it like a pair of army boots.

    Waxing I'm sure I wax more often than I need to, but I enjoy it. But I only wax after I've fully washed the car. I never wax after just doing a QD wipedown, even if the car looks clean. I wash and dry as outlined above, then apply whatever wax/sealant I'm in the mood for either with a clean 9006 pad on the DA (liquid wax/sealant) or by hand with a clean Hi-Tech foam applicator (paste wax/sealant). I always do this in the garage on cool paint, allow sufficient hazing time, then remove with a clean microfiber or three. Yeah, I go through a lot of towels!

    So, in the 13 months(roughly 56 weeks) since the above picture was taken I've washed the car maybe 18 times (give or take) and performed my QD wipedown perhaps 150 times or more (3 times a week for 56 weeks remember). Now that sounds like a lot of touching of the paint, doesn't it? But surely all that rubbing, all those QD wipedowns, have left their mark, right?

    Well, here are a few pictures I took of the car this morning. I have not polished it at all in more than a year. I've just been really, really, really careful. Oh, and my light source for these shots is the sun, on a bright, clear day. Harsh, huh?

    The hood:


    The C-pillar:


    The rear hatch:


    In all honesty, if I go over the entire car with a very critical eye, there are some very small marks present. But I have to go hunting for them. Otherwise, using good products and good techniques will keep your car looking great for a very long time.
    Michael Stoops
    Senior Global Product & Training Specialist | Meguiar's Inc.

    Remember, this hobby is supposed to be your therapy, not the reason you need therapy.

  2. #2
    Rasky's Auto Detailing RaskyR1's Avatar
    Join Date
    Dec 2007
    Location
    Eden Prairie, MN
    Age
    44
    Posts
    1,920
    Rep Power
    199

    Re: Maintaining the finish between polishing sessions

    Nice write up Mike!

    That just goes to show that car can remain swirl free for a long time if cared for properly. <?xml:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" /><o:p></o:p>

  3. #3
    Registered Member CosmoTiki's Avatar
    Join Date
    Feb 2008
    Location
    SoCal
    Posts
    50
    Rep Power
    12

    Thumbs up Re: Maintaining the finish between polishing sessions

    Amazing... and encouraging! Now that I have a better grasp on the "Do's" and "Don'ts", I think it's time to de-swirl my car and follow the M-I-O (Mike-in-Orange) regimen!

  4. #4
    aka: 23jam J. A. Michaels's Avatar
    Join Date
    Sep 2005
    Posts
    14,242
    Rep Power
    537

    Re: Maintaining the finish between polishing sessions

    Great write up Mike. Following those steps are the key to a well maintain swirl free finish. By the way your Cruiser looks great as always.
    quality creates its own demand

  5. #5
    Formerly 101impala Andy M.'s Avatar
    Join Date
    May 2004
    Location
    Philadelphia, PA
    Age
    52
    Posts
    3,969
    Rep Power
    347

    Re: Maintaining the finish between polishing sessions

    Nice write up Mike, thanks for taking the time. Your car looks great. The wheels you have on there aren't original are they? They really look nice on your car.

    Andy
    101impala
    Keeping MOL family friendly! If you need help or have a question, don't hesitate to shoot me an email or PM. 101impala@gmail.com
    Andy M. Moderator

  6. #6
    Registered Member yalerd's Avatar
    Join Date
    Jan 2006
    Location
    Santo Domingo, Dominican Republic
    Posts
    4,439
    Rep Power
    120

    Re: Maintaining the finish between polishing sessions

    Very well kept Mike
    Thanks for sharing

  7. #7
    Sr. Global Product & Training Spec Michael Stoops's Avatar
    Join Date
    Oct 2004
    Location
    Irvine, CA
    Posts
    21,401
    Rep Power
    1138

    Re: Maintaining the finish between polishing sessions

    Quote Originally Posted by 101impala View Post
    Nice write up Mike, thanks for taking the time. Your car looks great. The wheels you have on there aren't original are they? They really look nice on your car.

    Andy
    101impala
    No, those are after market wheels. Velox Performance VX6r to be precise - 17 x 7 at a lightweight 14lbs a piece. And the Velox factory color is almost a dead on match for the Chrysler factory paint on my car! In fact, I've seen body shops do a worse job matching body panels!

    Thanks for the feedback gang!
    Michael Stoops
    Senior Global Product & Training Specialist | Meguiar's Inc.

    Remember, this hobby is supposed to be your therapy, not the reason you need therapy.

  8. #8
    Reforming paint abuser RogueGypsy's Avatar
    Join Date
    Mar 2008
    Location
    The Great NorthWet
    Posts
    279
    Rep Power
    14

    Re: Maintaining the finish between polishing sessions



    Nice job. I was going to ask why you would apply #16 over #21 before a road trip??? It seems #21 is much slicker and should shed dust and debris easier than #16. But by the end of the write-up it seems to make sense, the added protection from the cross country sand blasting, sure seemed to hold up well in the last pics from a year later.

    Thanks, very informative.
    Life isn't about 'weathering the storm', it's about learning to dance in the rain.

  9. #9
    Got Megs? Jokeman's Avatar
    Join Date
    Apr 2007
    Location
    Boston
    Posts
    789
    Rep Power
    20

    Re: Maintaining the finish between polishing sessions

    Well done Mike! Car looks great for not being polished in that long a time. How many miles a year do you drive it?

  10. #10
    Sr. Global Product & Training Spec Michael Stoops's Avatar
    Join Date
    Oct 2004
    Location
    Irvine, CA
    Posts
    21,401
    Rep Power
    1138

    Re: Maintaining the finish between polishing sessions

    Quote Originally Posted by Jokeman View Post
    Well done Mike! Car looks great for not being polished in that long a time. How many miles a year do you drive it?
    Just shy of 9,000 miles/year.
    Michael Stoops
    Senior Global Product & Training Specialist | Meguiar's Inc.

    Remember, this hobby is supposed to be your therapy, not the reason you need therapy.

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 4
    Last Post: Oct 21st, 2008, 09:19 AM
  2. What should I do for a new car's first wax?
    By bobbyt in forum Detailing 101
    Replies: 6
    Last Post: Aug 19th, 2006, 04:59 PM
  3. Replies: 4
    Last Post: Dec 25th, 2005, 01:34 PM
  4. Car's that got detailed so far
    By JG_Detailing in forum Show Off Your Latest Detail Work
    Replies: 2
    Last Post: Aug 12th, 2005, 09:57 AM
  5. How do you wash car's ?
    By orange monkeyee in forum Detailing 101
    Replies: 1
    Last Post: Oct 26th, 2004, 03:35 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •