Although when detailing an engine compartment for a customer I go thru the entire process including misting with water, there are times and/or situations where this is not feasible or warranted. So even though I have detailed the cleaning of engine compartments for full details, here's a recently completed "maintenance" waterless engine detail process.
I am having a new set of custom-designed seats placed in the Vette as well as some custom leather shift/e-brake boots and various interior panels. Had to leave the Vette at the upholstery shop for about 10 days so they could do all the test fittings and remove the old components and replace with temporary ones while they design/cut the foam for the seats, mount them to the rails, install electronics, etc.
Well, while they might be great with leather, vinyl, stitching and interior they have no idea how to care for a car. Car was left in a dusty parking area under a tree so that "it would be in the shade" according to the shop manager...
Picked up the car, brought it home and found this...
Not horribly dirty but loads of dust and some leaf collection. Decided to go with a maintenance cleaning and use just M40 instead of the entire water/degreaser/cleaners/conditioners/dressing procedure.
First up was pulling the Vette into the covered work area, popping the hood and removing the major engine compartment seals...
Take an engine detailing brush and agitate the major built-up dirt and loosen leaves/twigs...
Use Shop Vac to suction out all loose dirt and debris...
All vacuumed up...
Grabbed some M40 and a terry towel and cleaned engine compartment seals. Can you say dirty...
Take another terry towel and scrub all plastic, vinyl, and rubber surfaces with M40 using ample amounts of product...
Take an foam brush applicator and liberally apply M40 to cowl plastic area...
Follow up with clean microfiber to wip away excess...
Use clean microfibers to wipe up any excess in the remainder of the engine compartment and wipedown painted surfaces with Meguiar's Last Touch.
Finished product...
Funny side note...notice the windshield washer fluid reservoir tank. It's "sweating" as the water is condensing on the outside. I asked my girlfriend to fill it with water and she did so from the ice water in the fridge. Hence the condensation. Hey, at least she helped!
As always, thanks for looking guys...
I am having a new set of custom-designed seats placed in the Vette as well as some custom leather shift/e-brake boots and various interior panels. Had to leave the Vette at the upholstery shop for about 10 days so they could do all the test fittings and remove the old components and replace with temporary ones while they design/cut the foam for the seats, mount them to the rails, install electronics, etc.
Well, while they might be great with leather, vinyl, stitching and interior they have no idea how to care for a car. Car was left in a dusty parking area under a tree so that "it would be in the shade" according to the shop manager...
Picked up the car, brought it home and found this...
Not horribly dirty but loads of dust and some leaf collection. Decided to go with a maintenance cleaning and use just M40 instead of the entire water/degreaser/cleaners/conditioners/dressing procedure.
First up was pulling the Vette into the covered work area, popping the hood and removing the major engine compartment seals...
Take an engine detailing brush and agitate the major built-up dirt and loosen leaves/twigs...
Use Shop Vac to suction out all loose dirt and debris...
All vacuumed up...
Grabbed some M40 and a terry towel and cleaned engine compartment seals. Can you say dirty...
Take another terry towel and scrub all plastic, vinyl, and rubber surfaces with M40 using ample amounts of product...
Take an foam brush applicator and liberally apply M40 to cowl plastic area...
Follow up with clean microfiber to wip away excess...
Use clean microfibers to wipe up any excess in the remainder of the engine compartment and wipedown painted surfaces with Meguiar's Last Touch.
Finished product...
Funny side note...notice the windshield washer fluid reservoir tank. It's "sweating" as the water is condensing on the outside. I asked my girlfriend to fill it with water and she did so from the ice water in the fridge. Hence the condensation. Hey, at least she helped!
As always, thanks for looking guys...
Comment