Tweet
I have a G110V2 with the standard W68DA Velcro Backing Plate and the W67DA Velcro Backing Plate. Is it ok to use the W68DA with foam interface pad and a Uningrit sanding/ finishing disc or should I just buy the Unigrit backing plate?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: Unigrit Backing Plate
If you're going to be sanding, you definitely want the 6" Unigrit backing plate and foam interface pad. Sanding is potentially so much faster cutting than any soft of polishing you could do with a DA that it really pays to use the correct tools all around. If you use the W68DA you won't get even pressure on the abrasive media, and that will lead to a lack of uniform sanding, and you want your sanding to be as uniform as possible. The W67DA plate simply isn't large enough to fully support the abrasive media either. If ever there was a time when the backing plate was absolutely critical, this is it.Michael Stoops
Senior Global Product & Training Specialist | Meguiar's Inc.
Remember, this hobby is supposed to be your therapy, not the reason you need therapy.
-
Re: Unigrit Backing Plate
Thanks MikeComment
-
Im still confused so what are the product numbers you suggest?Comment
-
Re: Unigrit Backing Plate
The unigrit backing plate is the S6BP.Comment
Comment