I'm working on an older paint finish that is black single stage lacquer. It's had a little paint work on one of the quarter panels and I can see a blend line. It looks like the front 1/4 or so of the quarter panel was touched up at some point probably several years ago. As it goes toward the back of the car it stops abruptly and looks like a pretty harsh attempt at a burn in. Is there a way for me to make it look better and less noticeable?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment