Tweet
I plan on fixing a stone chip in my Traverse. On another thread it was suggested to use 10% IPA to clean out the chip. The lowest I can find is70%. Will I do any damage by using 70% IPA? Or should I just do a spot wash on the chip to clean it out?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: Using IPA on a stone chip
Just dilute it with water to get the concentration you want.
Example: 1 part 70% alcohol to 4 parts water = about 16% alcohol.
Bill -
Re: Using IPA on a stone chip
Thanks BillComment
-
Re: Using IPA on a stone chip
use it full strength on a Q-tip, a few times.
you want to make sure you don't have any oils in the chip from wax or the elements.
The paint won't stick if there is anything in the chip.Comment
Comment