G220V2 or G110V2 - Replacement wrench and carbon brushes

[scoutfai]

Hi there. I found a used G220v2 on sale in a forum but with two things missing.
1) the wrench
2) the pair of back up carbon brushes.

I want to ask does anyone knows what after market tool can replace the wrench? A spanner seems to be too thick to insert into the slot of the machine. The seller claims a normal wrench can easily found in any ordinary hardware store but I have yet to see anything that slim. I see a lot of spanner but not that kind of slim wrench comes together with the machine. If anyone has such tool with you can you kindly post a picture, and how much it costs?

And the missing pair of back up carbon brushes, that concerns me a bit because I have no idea usually how long it takes for the brushes to be replaced. The machine is 1 year old and according to the seller is been used less than 5 times, each time on a full car detailing. Just worry that to buy a replacement carbon brushes alone from Meguiar's distributor later in the future will be too cost ineffective.
BTW is the G220v2 or G110v2 only can use carbon brushes manufactured by Meguiar's? Can I get some other carbon brushes and it still fit and does the job?

[J4o2el7]

Not 100% sure on the wrench, but I'm sure you can buy for less the 10 dollars through meguairs, same with the carbon brushes. If it's a good deal don't pass it up because of that!

[iMak]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

I lost my wrench and the backup carbon brushes for my G220v2. Could somebody guide me where to find them online?

[HCAD]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

And another mystery goes unsolved.

[KBzPTGT]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

try here: http://www.carbonbrush.com/brushes.htm

[KBzPTGT]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

here's the brushes for the PC7424xp: https://www.ereplacementparts.com/po...97_139651.html

D@MN, just noticed this is a really old thread

[HCAD]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

try here: http://www.carbonbrush.com/brushes.htm

That page looks like it has possibilities! Thanks.

Now to find the right one out of those offered.

[HCAD]

Re: G220V2 or G110V2 - Replacement wrench and carbon brushes

Updating this thread for those searching carbon brushes to fit the G110v2. The link above that KBzPTGT gave, www.carbonbrush.com, is a good source! I spoke with one of the reps and he was very helpful. After I gave him the measurements of my last unused set of carbon brushes, he did some calculations, suggested a part #C010, and it is currently running my machine as we speak. Success!!!