I've got a 2006 Toyota Tacoma red finish that I have maintained using Klasse All In One since new. Recently I noticed some water spots, and they are etched in unfortunately. I tried a good hand wash, then vinegar, then the Meguire's Clay Bar kit. Then I used Sonus SFX-1 with my Porter Cable dual action polisher. No appreciable improvement. I've moved on to Meguire's D-300 correction compound with some 6" Meguire's cutting pads - still have the spots. Really frustrated... defect removal is not my forte. Looking for tips on technique, or other steps I can take to get these spots out please. It's my first time with these cutting pads - maybe I'm not using them correctly...
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Bad Water Spot Removal
Collapse
X
Comment