• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

Question about pads for MT310

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Question about pads for MT310

    Recently I bought MT310 DA polisher together with 5" and 6" foam pads but still have problems in tight areas so I am thinking about smaller pads 3" and 4" but as I can see label on machine says that 5" and 6" pads should be use so I am interested if I still can use 4" pads with DBP3 backing plate with MT310 or I have to buy one more machine which is not an option.

    Thx
    Tags: None
  • #2
    Re: Question about pads for MT310

    Welcome to Meguiar's Online Yes, 3" backing plate will fit and it can be used on MT300/310 with smaller buffing pads.

    Comment

    • #3
      Re: Question about pads for MT310

      Thank you

      Comment

      Previous template Next
      Working...
      X
      gtag('config', 'UA-161993-8');