The 3" DMC3 discs are in "out of stock" status at most dealer locations.
I was lamenting not having them available for more aggressive correction if needed.
I then realized that the DMX5 Xtra Cut Microfiber discs might be a better alternative.
It would seem for spot repair the 3" Microfiber cutting disc might have an edge. It would be more agrgessive than the 5" cutting disks.
However the 5" "Xtra" might be equal in aggressiveness and easier to handle on larger surfaces.
Does anyone have experienced thoughts using the two products for defect correction?
I was lamenting not having them available for more aggressive correction if needed.
I then realized that the DMX5 Xtra Cut Microfiber discs might be a better alternative.
It would seem for spot repair the 3" Microfiber cutting disc might have an edge. It would be more agrgessive than the 5" cutting disks.
However the 5" "Xtra" might be equal in aggressiveness and easier to handle on larger surfaces.
Does anyone have experienced thoughts using the two products for defect correction?
Comment