• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

M105 Consistency

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • M105 Consistency

    Complete novice here.I picked up a bottle of M105 at Walmart to use with a porter cable DA polisher with a orange hex cut pad. YouTube shows people priming the pads with 4 or 5 pea size drops. The liquid in the M105 I picked up is white with the consistency of water,it doesn't sit on top of the pad, it immediately soaks in.I shook it up very well.
    Does the product usually vary in consistency this much?

  • #2
    Re: M105 Consistency

    Hi Sawyer65,

    Welcome to Meguiar's Online. Sorry to hear about your experience. M105 should not be the consistency of water. Please contact our Solutions Hub at 800-347-5700 or customercare@meguiars.com. With some type of proof of purchase, we can send you a replacement or refund. You are also welcome to return to the store you purchased it from, to try to exchange for another. Either way.

    Again we apologize for any inconvenience. It may have been exposed to prolonged extreme heat or cold.
    Nick Winn
    Product & Training Specialist | Meguiar's Online Forum Administrator
    Meguiar's Inc.
    Irvine, CA
    nawinn@meguiars.com

    Comment

    Working...
    X
    gtag('config', 'UA-161993-8');