Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA
nawinn@meguiars.com
800-854-8073 ext 3845
CLICK HERE TO REGISTER AS A MEMBER FOR MEGUIAR'S ONLINE DISCUSSION FORUM
I'm looking forward to getting some!
M101 is a favorite of mine. I would hate to see it phased out. It is my go-to swirl killer!
I have yet to use M110 so I can't make any comparisons to M101 yet...but I do have M110 on order!
![]()
Any word on how M110 is regarding staining trim? I know the "official" word is likely to still tape off, but is it as bad as say M105 regarding staining?
I always get excited to try a new compound that doesn't stain because it saves me taping off... Until I have to use twice as many passes to get less of a result than m101/m105 would have gotten me in the first place.
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA
nawinn@meguiars.com
800-854-8073 ext 3845
CLICK HERE TO REGISTER AS A MEMBER FOR MEGUIAR'S ONLINE DISCUSSION FORUM
Quick question, I see no mention if this product is OK to use by hand. I frequently use M105 by hand for nook and cranny areas that are very hard or impossible to hit by machine, and quick touch ups for scratches and scuffs where it's faster and more practical to simply rub the small area out by hand compared to breaking out the machine.
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA
nawinn@meguiars.com
800-854-8073 ext 3845
CLICK HERE TO REGISTER AS A MEMBER FOR MEGUIAR'S ONLINE DISCUSSION FORUM
M110 Ultra Pro Speed Compound via Meguiar's D/A Microfiber Cutting Disc
![]()
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA
nawinn@meguiars.com
800-854-8073 ext 3845
CLICK HERE TO REGISTER AS A MEMBER FOR MEGUIAR'S ONLINE DISCUSSION FORUM
Looking very forward to putting these new liquids through their paces!
P.S. I very much preferred the old flip top caps on the Mirror Glaze bottles...
There are currently 1 users browsing this thread. (0 members and 1 guests)