If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It is a stand alone form of protection and it would perform better on paint as the first layer. On the back of the bottle, Meguiar's has a statement where they mention for best results use their D1801 iron decon, clay, at least a one step correction (aka polishing) and then apply.
Now if you are applying it over an all in one then yes it can be done but its longevity will be slightly affected.
It is a stand alone form of protection and it would perform better on paint as the first layer. On the back of the bottle, Meguiar's has a statement where they mention for best results use their D1801 iron decon, clay, at least a one step correction (aka polishing) and then apply.
Now if you are applying it over an all in one then yes it can be done but its longevity will be slightly affected.
I second The Guz's comments and also wanted to mention to remember, if one decides to apply a non SiO2 based product over a SiO2 product like our M27, the water beading characteristics of the M27 (in this example) will be diminished. For example, if someone applies M27, then applies a product like our M26 Hi Tech Yellow Wax over the top, the water beading characteristics will reflect the M26 Hi Tech Yellow Wax.
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA nawinn@meguiars.com
Just to clarity... M27 should be applied over fresh clean paint. Applying a wax first, THEN M27 Sealant afterwords is not recommended for best results.
I second The Guz's comments and also wanted to mention to remember, if one decides to apply a non SiO2 based product over a SiO2 product like our M27, the water beading characteristics of the M27 (in this example) will be diminished. For example, if someone applies M27, then applies a product like our M26 Hi Tech Yellow Wax over the top, the water beading characteristics will reflect the M26 Hi Tech Yellow Wax.
Just to clarity... M27 should be applied over fresh clean paint. Applying a wax first, THEN M27 Sealant afterwords is not recommended for best results.
Correct?
Correct, and I would add a bit more, applied to "fresh clean & polished paint", for best results.
Nick Winn
Product & Training Specialist | Meguiar's Online Forum Administrator
Meguiar's Inc.
Irvine, CA nawinn@meguiars.com
Comment